H&R Sport Springs - Lowering Springs for BMW E36
by H&R
Key Features
- Fits E36 318i, 323i, 325i, 328i - verify M3 part number separately
- Approx 40mm drop front and rear over stock ride height
- Progressive spring rate - softer initial travel, firms up mid-stroke
- Works with stock dampers, best paired with Bilstein B6 or equivalent
- Check rear trailing arm geometry after install - camber can shift
- Made in Germany, TUV certified
Product Details
- Brand
- H&R
- Category
- Lowering Springs
- ASIN
- B07VT1V6L8
Check if it fits your BMW
H&R Sport Springs - Lowering Springs for BMW E36 — Overview
These are H&R's bread-and-butter sport springs for the E36 chassis, covering the 318i, 323i, 325i, and 328i depending on the part number you select. Drop is typically around 40mm front and rear, which tightens up the factory ride height without going so low that you are scraping on every parking garage lip. H&R uses progressive winding, so the spring rate climbs as compression increases and daily driving on stock or upgraded shocks stays manageable. If you are choosing between these and Eibach Pro-Kit, the H&R Sport tends to drop slightly more and runs a bit stiffer - pick Eibach if you want the gentler daily setup, pick these if you want the car to look and feel like it means it. Either way, swap the dampers at the same time if yours have any miles on them, because worn shocks and new springs is a rough combination.
