ALLOYWORKS Charge Pipe Kit for BMW F82 M4 S55

F82

$228.00

Buy on Amazon

Key Features

Fits BMW F82 M4 with S55 3.0L
Charge pipe kit for turbo-to-intake boost plumbing
Alloy construction replaces failure-prone factory plastic sections
Good choice for tuned or hard-driven S55 cars
Check coupler alignment before fully tightening clamps
Verify compatibility with aftermarket intercooler connections

Product Details

Category: Charge Pipes
ASIN: B0C6KKP3CG

Check if it fits your BMW

ALLOYWORKS Charge Pipe Kit for BMW F82 M4 S55 — Overview

This is a full charge pipe kit for the F82 M4 with the S55 3.0L twin-turbo setup. It replaces the factory plastic-style boost piping with alloy piping that is less likely to split once you start leaning on the car. If your stock pipes are original and the car sees higher boost, hard pulls, or track heat, this is one of the first weak points I’d address. It fits the charge-pipes category exactly - not an intercooler, not a turbo inlet kit.

I’d pick this over staying stock if your F82 is tuned or you just want to stop worrying about brittle factory pipes failing under load. Compared with piecing together individual sections, a complete kit is usually the cleaner route when you’re already in there. Just make sure you confirm exact F82 fitment against your model year and any existing aftermarket intercooler or coupler setup. On install, expect the usual tight BMW turbo-side access and take your time getting every clamp seated straight.